FRP desulfurization dust collector effectively prevents energy waste
Small and medium-sized industrial FRP desulfurization precipitators, FRP desulfurization precipitators mainly refer to the existing fast-installed FRP desulfurization precipitators. The FRP desulfurization precipitators have been developed, improved, and improved for more than 20 years. Fast shutdown and convenient use are welcomed by the majority of units. However, glass fiber reinforced plastic desulfurization dust collectors are often affected by factors such as fluctuations in steam loads, changes in coal combustion types, and operation management levels. Glass fiber reinforced plastic desulfurization dust collectors have exposed many problems. As a result, the actual output and efficiency of the FRP desulfurization dust collector is far lower than the output and efficiency of the noon design. This not only affects the normal steam supply of the FRP desulfurization dust collector, but also causes a huge waste of energy. At the same time, the FRP desulfurization dust collector also limits its own development of. In order to give full play to the huge potential of the existing fast-installed FRP desulfurization dust collectors, FRP desulfurization dust collectors must be targeted at their problems. The FRP desulfurization dust collectors should be as original as possible (the original plant, the original FRP dust collector, and the original suction fan). Underground reconstruction, FRP desulfurization dust collectors can work together under the condition of poor coal quality, and restore its nameplate output. FRP desulfurization dust collectors improve their efficiency and reduce smoke and dust pollution, thereby improving the safety, economy and environmental protection of FRP dust collectors. Level, this is the most realistic and economical way. However, the reconstruction task is arduous and complicated. If the combustion of low-quality coal is considered, it is difficult to ensure the output of the FRP desulfurization dust collector; if the increase of the heating surface at the tail of the FRP desulfurization dust collector is considered to reduce the exhaust temperature and improve the efficiency of the FRP desulfurization dust collector, FRP For the desulfurization and dust collector, the tail heating surface is easy to accumulate ash and corrosion; if you consider adding coal saving measures, you need to consume more electricity. This is indeed a relatively complex system project. It is very difficult to consider both the whole and the specific contradictions of the FRP desulfurization and dust collector. Therefore, for a long time, due to various reasons and conditions.
| Copyright © 2015 Hebei Yiyang Antai Environmental Protection Equipment Co., Ltd. - FRP pickling tank | FRP purification tower | FRP desulfurization tower | FRP mixing tank All rights reserved. |
Address: Chengnan Development Zone, Huanghua City, Hebei Province Telephone: 0317-5628177 Mobile: 15233270999
Fax: 0317-5625066 Website: http://cafethera.com Technical Support: Cangzhou Xianyue Network QQ79471598